user manual

5-19
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 5 Configuring Filters and QoS
A Wireless QoS Deployment Example
WEP Set on the Wireless Phone
If WEP is set on your wireless phone, you must set an identical WEP key for the interactive voice VLAN.
Follow these steps to set the WEP key.
Step 1 Enter the phone’s WEP key in the WEP Key 1 Encryption Key field.
Step 2 In the Key Size drop-down menu, select the WEP key size set on the phone.
Step 3 Click Apply or OK. The configuration is complete.
WEP Not Set on the Wireless Phone
If a WEP key is not set on the wireless phone, you must complete the configuration by following these
steps:
Step 1 Browse to the VLAN Setup page.
Step 2 In the Single VLAN ID which allows Unencrypted packets field, enter the Voice VLAN ID.
Step 3 Set the Optionally allow Encrypted packets on the unencrypted VLAN to yes (Figure 5-19).
Figure 5-19 VLAN Setup page