user manual

5-15
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 5 Configuring Filters and QoS
Applying QoS
By Filter
Access point filters already allow the classification of traffic based upon Ethertype, Internet Protocol, or
IP Port. An example of a filter classifying traffic is shown on Figure 5-13.
Figure 5-13 Filters Priority Setting
The filters can be applied on interfaces or as a part of a VLAN policy group.
The access point has a default filter to classify all Spectralink voice traffic with voice priority. You do
not have to enable this filter, but you can modify the filter and apply it to a specific VLAN or interface.
Note To set up a filter, see the “Filter Setup” section on page 5-2.
A typical Spectralink filter configuration is shown on Figure 5-14.
Figure 5-14 Spectralink Filter Configuration