user manual

1-6
Cisco CRS-1 Carrier Routing System Multishelf System Upgrade and Conversion Guide
OL-12571-01
Chapter 1 Upgrading to a Multishelf System
How to Upgrade to a Multishelf System
Step 4
dsc serial serialNumber rack F rack
Example:
RP/0/RP1/CPU0:router(admin-config)# dsc serial
TBC0820052000000 rack F0
Configures the FCC identified by the serial number as an
FCC rack within the multishelf system.
• Replace serialNumber with the serial number of the
FCC.
• Replace rack with the FCC number as it appears in the
fabric cabling plan, which is described in Cisco CRS-1
Carrier Routing System Multishelf System
Interconnection and Cabling Guide.
• If you are configuring the system from a remote
location, you can use a command to display the serial
number. For more information, see Cisco IOS XR
Getting Started Guide.
Step 5
controllers fabric plane planeNumber
oim count 1
oim instance 0 location F
rack / slot /FM
Example:
RP/0/RP1/CPU0:router(admin-config)# controllers
fabric plane 0
RP/0/RP1/CPU0:router(admin-config)# oim count 1
RP/0/RP1/CPU0:router(admin-config)# oim
instance 0 location F0/SM9/FM
Configures a plane to operate in an FCC slot.
• Enter this command sequence for each of the eight
fabric planes.
• Replace planeNumber with the number of the plane (0
to 7) you want to configure.
• Replace rack with the FCC rack number assigned to the
FCC that hosts the plane.
• Replace slot with the FCC slot number that supports the
fabric plane you are configuring. Valid slot numbers are
SM0 to SM23.
• The plane numbers and slot numbers are determined by
the hardware installation and cabling. The software
configuration must match the hardware configuration.
For more information, see Cisco CRS-1 Carrier
Routing System Multishelf System Interconnection and
Cabling Guide.
• Enter this command once for each of the eight planes.
Note These configuration commands are ignored when
the FC/S cards are installed.
Step 6
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Commits the target configuration to the router running
configuration.
Step 7
end
Example:
RP/0/RP1/CPU0:router(admin-config)# end
Changes the mode from administration configuration mode
to administration EXEC mode.
Step 8
Apply power to the FCCs. Starts the FCCs.
Command or Action Purpose