user manual

J-107
Cisco Transport Manager Release 6.0 User Guide
78-16845-01
Appendix J Troubleshooting
J.10.9 Diagnostics Center Problems
J.10.9 Diagnostics Center Problems
The Diagnostics Center provides different diagnostics operations at the following different network
elements levels.
• Network Diagnostics
– Retrieve the current sync status and alarm status of all the nodes in the network.
– Support the network/node health statistics and manageability checks. At the network level, only
the node manageability check results are supported.
• Node Diagnostics
– Retrieve current sync status, node alarm status, IP address, and several other node attributes.
– Retrieve the sync status of all the cards in the node.
– Request a node resync.
– Request VSI partition data and also perform VSI consistency checks on the node.
– Support node health statistics such as SNMP success counts and FTP/TFTP success/failure
counts.
– Perform node manageability checks such as IP reachability and SNMP community string
checks.
• Card Diagnostics
– Retrieve card-level information (such as sync status, card status, and firmware revision)
– Retrieve card CPU usage on cards that support this functionality
– Retrieve the memory pool usage information on cards that support this functionality
– Retrieve the memory buffer pool usage Information on cards that support this functionality
– Retrieve card-level, real-time statistics, if any
– Retrieve information about all lines and paths that are in loopback on the card
– Retrieve information about currently running BERT tests on the card
– Retrieve information about currently running IMA link tests
• Port Diagnostics
– Retrieve the port-level attributes such as port status
– Perform loopback
– Perform start/stop/modify BERT
– Retrieve the results and/or current status of the BERT
– Monitor the scheduled grooming results
– Configure the on-demand grooming
– Retrieve the port-level, real-time statistics
• Line Diagnostics
– Retrieve the line-level attributes such as line status and loopback status
– Perform loopback
– Perform start/stop/modify BERT
– Retrieve the results and/or current status of the BERT