user manual

3-6

Cisco 7304 Router MIB Specifications Guide

OL-4925-02

Chapter 3 MIB Specifications

CISCO-ASPP-MIB

The CISCO-ASPP MIB provides configuration and operational information on asynchronous polled

protocols such as the asynchronous security protocols that alarm-monitoring companies use. The

protocols are handled in Pass-through mode. ASPP handles the receiving and sending of asynchronous

blocks.

CISCO-ATM-EXT-MIB

The CISCO-ATM-EXT-MIB contains extensions to the Cisco ATM module that are used to manage

ATM entities. It provides additional AAL5 performance statistics for a virtual channel connection (VCC)

on an ATM interface.

Note There are no constraints on this MIB and the ATM-EXT-MIB has only one table. The cAal5VccExtTable

augments the aal5VccTable of the ATM-MIB. The aal5VccTable contains additional AAL5 performance

parameters.

CISCO-BCP-MIB

The CISCO-BCP-MIB (based on RFC 2878) (Bridging Control Protocol) contains objects to configure,

enable, and disable bridge modules on both ends of point-to-point links. The Cisco 7304 router uses the

BCP for transporting Ethernet frames over SONET and DPT networks. The BCP-MIB manages and

monitors Bridge Control Protocol configuration and information on subnetwork interfaces using the

family of Point-to-Point Protocols.

The CISCO-BCP-MIB contains the following tables:

• bcpOperTable—Describes the current operational status information for a particular link. For all

entries in ifTable with ifType ppp(23), there will be an entry in this table.

• bcpConfigTable—Shows the BCP configuration information (for example, the current configuration

for spanning tree, line identification option).

Table 3-4 lists the constraints that the router places on objects in the CISCO-BCP-MIB. Also see the table of

new MIB objects which follows. For detailed definitions of MIB objects, see the MIB.

Table 3-4 CISCO-BCP-MIB Constraints

MIB Object Notes

bcpOperTable

•

bcpOperStatus Possible values:

open(1)

closed (2)

listening(3)

bcpConfigTable

•

bcpConfigBridgeIdControl Read-only. Possible values: enabled(1), disabled(2)

• bcpConfigLineIdControl Read-only. Possible values: enabled(1), disabled(2)