user manual

3-13

Cisco 7304 Router MIB Specifications Guide

OL-4925-02

Chapter 3 MIB Specifications

CISCO-DLSW-MIB

The CISCO-DLSW-MIB contains objects to manage data-link switches.

CISCO-DSPU-MIB

The CISCO-DSPU-MIB contains objects to configure and manage Cisco downstream physical

unit (DSPU) objects.

CISCO-ENTITY-ALARM-MIB

The CISCO-ENTITY-ALARM-MIB enables the Cisco 7304 router to monitor alarms generated by

system components, such as the chassis, slots, modules, power supplies, fans, and ports.

For a component’s alarms to be monitored, the component must be defined by a row in the

entPhysicalTable of the ENTITY-MIB in the “ENTITY-MIB” section on page 3-36 of this guide.

Note The Cisco 7403 router temperature, power supplies, and fan monitoring are implemented in the

CISCO-ENTITY-SENSOR-MIB instead of the CISCO-ENTITY-ALARM-MIB. The temperature

sensors are supported at the line card level, not the chassis level.

MIB Constraints

Table 3-6 lists the constraints that the Cisco 7304 router places on objects in the

CISCO-ENTITY-ALARM-MIB. For detailed definitions of MIB objects, see the MIB.

The MIB table, entPhysicalTable, identifies the physical system components in the router. The following

list describes the table objects for the CISCO-ENTITY-ALARM-MIB:

Table 3-6 CISCO-ENTITY-ALARM-MIB Constraints

MIB Object Notes

ceAlarmDescrTable

•

ceAlarmDescrSeverity Read-only.

ceAlarmFilterProfileTable

•

ceAlarmFilterIndex

• ceAlarmFilterStatus

• ceAlarmFilterAlias

• ceAlarmFilterAlarmsEnabled

• ceAlarmFilterNotifiesEnabled

• ceAlarmFilterSyslogEnabled

The objects listed are not supported.

ceAlarmCutOff Not supported.

ceAlarmFilterProfileIndexNext Not supported.