user manual

Chapter 45 View Menu Commands
Running Config
45-2
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Running Config
Displays the router’s running configuration.
Show Commands
Displays the Show Commands dialog box, which lets you issue Cisco IOS show
commands to the router, view the output, and save the output to your PC. The
output file is saved with the default filename
show_<command>[router_ip_address].
The Show Commands dialog box can display the output from the following show
commands:
• show flash—Shows the contents of the router Flash memory.
• show startup-config—Shows the router startup configuration file.
• show access-lists—Shows all of the Access Control Lists (ACLs) commands
currently configured on the router.
• show diag—Shows information about the hardware installed in the router.
• show interfaces—Shows information about the configuration of each
interface and about the packets transferred over the interface.
• show protocols—Shows information about the network protocols configured
on each interface.
• show version—Shows information about the version of Cisco IOS software
running on the router.
• show tech-support—Shows the output from all of the other show
commands.
• show environment—Shows information about the router power supply. This
command may not appear in the Show Commands drop-down list if not
supported by your router.