user manual

Table Of Contents
Index
IN-15
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
installed software 8-1
LEDs 2-9
ports 12-25
soft reset 8-15
software compatibility 2-2
specifications A-8
temperature range A-6
third-party equipment 1-1, 10-10
thresholds
MIBs
14-23
timing
BITS. See BITS
parameters
9-7
pin connections 1-14
report 9-7
specifications A-3
TLS. See VLAN
traffic
monitoring
10-15
routing 12-23
traffic switching
multicard EtherSwitch
14-10
single-card EtherSwitch 14-11
transponder mode
diagram
14-6
for G-Series 14-5
G-Series card characteristics 14-9
one-port bidirectional 14-8
two-port bidirectional 14-7
two-port bidirectional G-Series card (diagram) 14-7
two-port unidirectional 14-8
tunnels
bidirectional low-order
10-21
DCC 10-10
IP encapsulated 10-11
two-fiber MS-SPRing. See MS-SPRing
U
unassigned secondary service state B-2
unicast 14-1
Unlocked,automaticInservice administrative state B-2
Unlocked administrative state B-2
Unlocked-disabled service state B-1
Unlocked-enabled service state B-1
user. See security
user data channel
2-20
user-defined alarms
See external alarms and controls
alarm contact installation. See alarm pin fields
(contacts)
user setup
9-1
V
VCAT, non-LCAS states 10-23
views. See CTC
virtual links
12-21
virtual local area network. See VLAN
virtual rings
11-30
VLAN
number supported
14-13
spanning tree 14-17
W
WAN 12-1
warning information 1-xxxii to ??
west port 11-12
workstation. See computer
workstation requirements
8-3
X
XC10G card
capacities
10-9