user manual
Table Of Contents
- Cisco ONS 15454 SDH Reference Manual
- Contents
- About this Guide
- Shelf and FMEC Hardware
- Common Control Cards
- Electrical Cards
- Optical Cards
- Ethernet Cards
- Storage Access Networking Cards
- Card Protection
- Cisco Transport Controller Operation
- Security and Timing
- Circuits and Tunnels
- SDH Topologies and Upgrades
- CTC Network Connectivity
- Alarm Monitoring and Management
- Ethernet Operation
- Hardware Specifications
- A.1 Shelf Specifications
- A.2 SFP Specifications
- A.3 General Card Specifications
- A.4 Common Control Card Specifications
- A.5 Electrical Card and FMEC Specifications
- A.5.1 E1-N-14 Card Specifications
- A.5.2 E1-42 Card Specifications
- A.5.3 E3-12 Card Specifications
- A.5.4 DS3i-N-12 Card Specifications
- A.5.5 STM1E-12 Card Specifications
- A.5.6 BLANK Card
- A.5.7 FMEC-E1 Specifications
- A.5.8 FMEC-DS1/E1 Card Specifications
- A.5.9 FMEC E1-120NP Card Specifications
- A.5.10 FMEC E1-120PROA Card Specifications
- A.5.11 FMEC E1-120PROB Card Specifications
- A.5.12 E1-75/120 Impedance Conversion Panel Specifications
- A.5.13 FMEC-E3/DS3 Card Specifications
- A.5.14 FMEC STM1E 1:1 Card Specifications
- A.5.15 FMEC-BLANK Card Specifications
- A.5.16 MIC-A/P Card Specifications
- A.5.17 MIC-C/T/P Card Specifications
- A.6 Optical Card Specifications
- A.6.1 OC3 IR 4/STM1 SH 1310 Card Specifications
- A.6.2 OC3 IR/STM1 SH 1310-8 Card Specifications
- A.6.3 OC12 IR/STM4 SH 1310 Card Specifications
- A.6.4 OC12 LR/STM4 LH 1310 Card Specifications
- A.6.5 OC12 LR/STM4 LH 1550 Card Specifications
- A.6.6 OC12 IR/STM4 SH 1310-4 Card Specifications
- A.6.7 OC48 IR/STM16 SH AS 1310 Card Specifications
- A.6.8 OC48 LR/STM16 LH AS 1550 Card Specifications
- A.6.9 OC48 ELR/STM16 EH 100 GHz Card Specifications
- A.6.10 OC192 SR/STM64 IO 1310 Card Specifications
- A.6.11 OC192 IR/STM64 SH 1550 Card Specifications
- A.6.12 OC192 LR/STM64 LH 1550 Card Specifications
- A.6.13 OC192 LR/STM64 LH ITU 15xx.xx Card Specifications
- A.7 Ethernet Card Specifications
- A.8 Storage Access Networking Card Specifications
- Administrative and Service States
- Network Element Defaults
- Index
12-22
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
Chapter 12 CTC Network Connectivity
12.3 Provisionable Patchcords
Provisionable patchcords are required on both ends of a physical link. The provisioning at each end
includes a local patchcord ID, slot/port information, remote IP address, and remote patchcord ID.
Patchcords appear as dashed lines in CTC network view.
Table 12-5 lists the supported card combinations for client and trunk ports in a provisionable patchcord.
Note If the OCSM card is installed in Slot 8, provisionable patchcords from OC-N ports to the following cards
are not supported on the same node: MXP_2.5G_10G, TXP_MR_10G, TXP(P)_MR_2.5G,
MXP_2.5G_10E, TXP_MR_10E, 32MUX-O, 32DMX-O, 32-WSS, or 32-DMX.
Table 12-6 lists the supported card combinations for client-to-client ports in a patchcord.
Table 12-5 Cisco ONS 15454 SDH Client/Trunk Card Combinations for Provisionable Patchcords
Trunk Cards
Client Cards
MXP_2.5G_10G/
TXP_MR_10G
TXP(P)_MR_
2.5G
MXP_2.5G_10E
/
TXP_MR_10E
32MUX-O
32DMX-O
32-WSS/
32-DMX ADxC 4MD
MXP_2.5G_10G/
TXP_MR_10G
———YesYesYesYes
TXP(P)_MR_2.5G ———YesYesYesYes
MXP_2.5G_10E/
TXP_MR_10E
———YesYesYesYes
MXP(P)_MR_2.5G ———YesYesYesYes
OC-192 Yes — Yes ————
OC-48 Yes Yes Yes ————
OC-192 ITU ———YesYesYesYes
OC-48 ITU ———YesYesYesYes
Table 12-6 Cisco ONS 15454 SDH Client/Client Card Combinations for Provisionable Patchcords
Client Cards
MXP_2.5G_10G/
TXP_MR_10G TXP(P)_MR_2.5G
MXP_2.5G_10E/
TXP_MR_10E
MXP_2.5G_10G/
TXP_MR_10G
Yes — Yes
TXP(P)_MR_2.5G —Yes—
MXP_2.5G_10E/
TXP_MR_10E
Yes — Yes