user manual

9-4
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
Chapter 9 Security and Timing
9.1.1 Security Requirements
Table 9-2 shows the actions that each user privilege level can perform in network view.
Maintenance Software Download — X X X
Upgrade/Activate/Revert — — — X
Cross-Connect Cards: Switch/Lock/Unlock — X X X
Resource Usage: Delete — — X X
Overhead XConnect View X X X X
Diagnostic Retrieve/Lamp Test — X X X
Timing Source: Edit — X X X
Timing Report: View/Refresh X X X X
Audit Retrieve/Archive — — — X
Routing Table Retrieve X X X X
RIP Routing Table Retrieve X X X X
Test Access View X X X X
DWDM APC: Run/Disable/Refresh — X X X
WDM Span Check: Retrieve
Span Loss values, Reset
XX X X
Power Monitoring: Refresh X X X X
1. Provisioner user cannot change node name, contact parameters.
2. IP Address is not viewable for Retrieve, Maintenance, and Provisioning users.
3. The action buttons in the subtab are active for all users, but the actions can be completely performed only by the users assigned with the required security
levels.
Table 9-1 ONS 15454 SDH Security Levels—Node View (continued)
CTC Tab Subtab [Subtab]:Actions Retrieve Maintenance Provisioning Superuser
Table 9-2 ONS 15454 SDH Security Levels—Network View
CTC Tab Subtab [Subtab]: Actions Retrieve Maintenance Provisioning Superuser
Alarms — Synchronize/Filter/Delete
cleared alarms
XXXX
Conditions — Retrieve/Filter X X X X
History — Filter X X X X
Circuits — Create/Edit/Delete — — X X
Filter/Search X X X X