user manual
Table Of Contents
- Cisco ONS 15454 SDH Reference Manual
- Contents
- About this Guide
- Shelf and FMEC Hardware
- Common Control Cards
- Electrical Cards
- Optical Cards
- Ethernet Cards
- Storage Access Networking Cards
- Card Protection
- Cisco Transport Controller Operation
- Security and Timing
- Circuits and Tunnels
- SDH Topologies and Upgrades
- CTC Network Connectivity
- Alarm Monitoring and Management
- Ethernet Operation
- Hardware Specifications
- A.1 Shelf Specifications
- A.2 SFP Specifications
- A.3 General Card Specifications
- A.4 Common Control Card Specifications
- A.5 Electrical Card and FMEC Specifications
- A.5.1 E1-N-14 Card Specifications
- A.5.2 E1-42 Card Specifications
- A.5.3 E3-12 Card Specifications
- A.5.4 DS3i-N-12 Card Specifications
- A.5.5 STM1E-12 Card Specifications
- A.5.6 BLANK Card
- A.5.7 FMEC-E1 Specifications
- A.5.8 FMEC-DS1/E1 Card Specifications
- A.5.9 FMEC E1-120NP Card Specifications
- A.5.10 FMEC E1-120PROA Card Specifications
- A.5.11 FMEC E1-120PROB Card Specifications
- A.5.12 E1-75/120 Impedance Conversion Panel Specifications
- A.5.13 FMEC-E3/DS3 Card Specifications
- A.5.14 FMEC STM1E 1:1 Card Specifications
- A.5.15 FMEC-BLANK Card Specifications
- A.5.16 MIC-A/P Card Specifications
- A.5.17 MIC-C/T/P Card Specifications
- A.6 Optical Card Specifications
- A.6.1 OC3 IR 4/STM1 SH 1310 Card Specifications
- A.6.2 OC3 IR/STM1 SH 1310-8 Card Specifications
- A.6.3 OC12 IR/STM4 SH 1310 Card Specifications
- A.6.4 OC12 LR/STM4 LH 1310 Card Specifications
- A.6.5 OC12 LR/STM4 LH 1550 Card Specifications
- A.6.6 OC12 IR/STM4 SH 1310-4 Card Specifications
- A.6.7 OC48 IR/STM16 SH AS 1310 Card Specifications
- A.6.8 OC48 LR/STM16 LH AS 1550 Card Specifications
- A.6.9 OC48 ELR/STM16 EH 100 GHz Card Specifications
- A.6.10 OC192 SR/STM64 IO 1310 Card Specifications
- A.6.11 OC192 IR/STM64 SH 1550 Card Specifications
- A.6.12 OC192 LR/STM64 LH 1550 Card Specifications
- A.6.13 OC192 LR/STM64 LH ITU 15xx.xx Card Specifications
- A.7 Ethernet Card Specifications
- A.8 Storage Access Networking Card Specifications
- Administrative and Service States
- Network Element Defaults
- Index
8-6
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
Chapter 8 Cisco Transport Controller Operation
8.5 CTC Window
SDH. You can connect to the ONS 15454 SDH through a LAN or modem, and you can establish TL1
connections from a PC or TL1 terminal. Table 8-3 lists the ONS 15454 SDH connection methods and
requirements.
8.5 CTC Window
The CTC window appears after you log into an ONS 15454 SDH (Figure 8-3). The window includes a
menu bar, toolbar, and a top and bottom pane. The top pane provides status information about the
selected objects and a graphic of the current view. The bottom pane provides tabs and subtabs to view
ONS 15454 SDH information and perform ONS 15454 SDH provisioning and maintenance. From this
window you can display three ONS 15454 SDH views: network, node, and card.
Table 8-3 ONS 15454 SDH Connection Methods
Method Description Requirements
Local craft Refers to onsite network connections
between the CTC computer and the
ONS 15454 SDH using one of the following:
• The RJ-45 (LAN) port on the
TCC2/TCC2P card
• The LAN pins on the ONS 15454 SDH
MIC-C/T/P FMEC
• A hub or switch to which the
ONS 15454 SDH is connected
• If you do not use Dynamic Host
Configuration Protocol (DHCP), you
must change the computer IP address,
subnet mask, and default router, or use
automatic host detection.
Corporate
LAN
Refers to a connection to the
ONS 15454 SDH through a corporate or
network operations center (NOC) LAN.
• The ONS 15454 SDH must be
provisioned for LAN connectivity,
including IP address, subnet mask,
default gateway.
• The ONS 15454 SDH must be
physically connected to the corporate
LAN.
• The CTC computer must be connected
to the corporate LAN that has
connectivity to the ONS 15454 SDH.
TL1 Refers to a connection to the
ONS 15454 SDH using TL1 rather than
CTC. TL1 sessions can be started from CTC,
or you can use a TL1 terminal. The physical
connection can be a craft connection,
corporate LAN, or a TL1 terminal.
—
Remote Refers to a connection made to the
ONS 15454 SDH using a modem.
• A modem must be connected to the
ONS 15454 SDH.
• The modem must be provisioned for
ONS 15454 SDH. To run CTC, the
modem must be provisioned for
Ethernet access.