user manual
Table Of Contents
- Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting Overview
- Troubleshooting Autonomous Access Points and Bridges
- Checking the LEDs on an Autonomous Access Point/Bridge
- Power Injector
- Checking Power
- Checking Basic Configuration Settings
- Antenna Alignment
- Running the Carrier Busy Test
- Running the Ping or Link Test
- Resetting the Autonomous Access Point/Bridge to the Default Configuration
- Reloading the Access Point/Bridge Image
- Obtaining the Autonomous Access Point/Bridge Image File
- Connecting to the Console Serial Port
- Obtaining the TFTP Server Software
- Troubleshooting Lightweight Access Points
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Industry Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Access Points and Bridges in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Maximum Power Levels
- Console Serial Cable Pinouts
- Priming Lightweight Access Points Prior to Deployment
- Configuring DHCP Option 43 for Lightweight Access Points
- Load-Dump Protection for Transportation Vehicles
- Glossary
- Index
C-3
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-06
Appendix C Access Point Specifications
Data rates IEEE 802.11b/g-compliant radio:
1, 2, 5.5 and 11 Mbps
6, 9, 12, 18, 24, 48, and 54 Mbps
(Depending on the regulatory domain in which the
access point/bridge is installed)
—
Non-overlapping
channels
3—
Antenna Integrated antenna
13-dBi patch array
Some external antennas:
5.2-dBi omnidirectional
12-dBi omnidirectional
9-dBi patch
10-dBi yagi
13.5-dBi yagi
14-dBi sector
21-dBi dish
(Depending on the regulatory region)
—
Environmental air space The access point/bridge and pow er injector provide adequate fire resistance and low sm oke-producing
characteristics su itable for operation in a building's environm ental air space, su ch as above su sp en d ed
ceilings, in accordance with S ection
3
00-22(C) of the National Electrical Code (NEC) and S ections
2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1, C22.1.
Caution The power module is not tested to UL 2043 and should not be placed in a building’s
air-handling spaces, such as above suspended ceilings.
Safety UL 60950
UL 2043
CSA C22.2 No. 60950
IEC 60950
EN 60950
Power injector:
UL 2043
Power injector and power module:
UL 60950
CSA C22.2 No. 60950
IEC 60950
EN 60950
Note The power injector and power module
must be used in an indoor
environment.
Table C-1 Access Point, Power Injector, and Power Module Specifications (continued)
Category Access Point Power Injector and Power Module