user manual

Contents
v
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-06
CHAPTER 4 Troubleshooting Autonomous Access Points and Bridges 4-1
Checking the LEDs on an Autonomous Access Point/Bridge 4-2
Normal Mode LED Indications for an Autonomous Access Point/Bridge 4-2
Power Injector 4-5
Checking Power 4-6
Checking Basic Configuration Settings 4-6
Default IP Address Behavior 4-6
Default SSID and Radio Behavior 4-6
Enabling the Radio Interface 4-7
SSID 4-7
Security Settings 4-8
Antenna Alignment 4-8
Running the Carrier Busy Test 4-8
Running the Ping or Link Test 4-9
Resetting the Autonomous Access Point/Bridge to the Default Configuration 4-10
Using the Web-Browser Interface 4-10
Using the CLI on an Autonomous Access Point/Bridge 4-10
Reloading the Access Point/Bridge Image 4-11
Web-Browser Interface 4-11
Browser HTTP Interface 4-11
Browser TFTP Interface 4-12
Obtaining the Autonomous Access Point/Bridge Image File 4-13
Obtaining the TFTP Server Software 4-14
CHAPTER 5 Troubleshooting Lightweight Access Points 5-1
Checking the LEDs on Lightweight Access Points 5-2
LED Indications 5-3
Power Injector 5-4
Checking Power 5-5
Using DHCP Option 43 5-5
Manually Configuring Controller Information Using the Access Point CLI 5-6
Connecting to the Console Serial Port 5-6
Configuring Controller Information 5-7
Clearing Manually Entered Controller Information 5-7
Manually Resetting the Access Point to Defaults 5-8
Returning the Access Point to Autonomous Mode 5-8
Using a Controller to Return the Access Point to Autonomous Mode 5-8