user manual
Table Of Contents
- Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
- Contents
- Preface
- Overview
- Installation Overview
- Mounting Overview
- Troubleshooting Autonomous Access Points and Bridges
- Checking the LEDs on an Autonomous Access Point/Bridge
- Power Injector
- Checking Power
- Checking Basic Configuration Settings
- Antenna Alignment
- Running the Carrier Busy Test
- Running the Ping or Link Test
- Resetting the Autonomous Access Point/Bridge to the Default Configuration
- Reloading the Access Point/Bridge Image
- Obtaining the Autonomous Access Point/Bridge Image File
- Connecting to the Console Serial Port
- Obtaining the TFTP Server Software
- Troubleshooting Lightweight Access Points
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Industry Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
- Administrative Rules for Cisco Aironet Access Points and Bridges in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- Access Point Specifications
- Channels and Maximum Power Levels
- Console Serial Cable Pinouts
- Priming Lightweight Access Points Prior to Deployment
- Configuring DHCP Option 43 for Lightweight Access Points
- Load-Dump Protection for Transportation Vehicles
- Glossary
- Index
IN-1
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-06
INDEX
A
antennas C-3
B
basic settings, checking 4-6
bridge configuration 1-1
C
caution x
configuring DHCP Option 43 G-2
connectors 1-5, C-1, C-3
console port 1-2
controller 1-2
conventions, document x
D
data rates 2-6, C-3
declarations of conformity B-1
default configuration, resetting to defaults 4-10
DHCP Option 43 5-5, G-1
DHCP pool G-2
documentation, conventions x
E
environmental conditions 2-6
F
FCC Declaration of Conformity B-2
FCC Safety Compliance 2-3
frequency range C-2
I
inline power 1-4
input power C-2
installation guidelines 2-3, 2-4
M
modulation C-2
N
network configurations 1-9
O
obtaining documentation xii
operating temperature C-1
P
package contents 2-6
pinouts, serial cable E-2
power
inline
1-4
input C-2
priming access points F-1