User manual

20-34
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 20 Configuring L2 Virtual Private Networks
Configuration Tasks for L2VPN
Example 20-25 shows how to configure Frame Relay same-port switching.
Example 20-25 Configuring Frame Relay Same-Port Switching
frame-relay switching
interface serial 1/0/0.1/1:0
encapsulation frame-relay
frame-relay intf-type nni
frame-relay interface-dlci 100 switched
exit
exit
connect connection1 serial1/0 100 serial1/0 200
Verifying Layer 2 Local Switching for Frame Relay
To verify configuration of the Layer 2 Local Switching feature, use the show connection
frame-relay-to-frame-relay command and the show frame-relay pvc command in privileged EXEC
mode.
Example 20-26 shows the output of the show connection frame-relay-to-frame-relay command, which
displays the local connection between a Frame Relay interface and a Frame Relay local switching
interface.
Example 20-26 show connection frame-relay-to-frame-relay Command Output
Router# show connection frame-relay-to-frame-relay
ID Name Segment 1 Segment 2 State
==================================================================
1 fr2fr Se3/0/0.1/1:0 100 Se3/0/0.1/2:0 200 UP
Example 20-27 shows the output of the show frame-relay pvc command, which shows a switched
Frame Relay PVC.
Example 20-27 show frame-relay pvc Command Output
Router# show frame-relay pvc 16
PVC Statistics for interface POS5/0 (Frame Relay NNI)
DLCI = 16, DLCI USAGE = SWITCHED, PVC STATUS = UP, INTERFACE = POS5/0
LOCAL PVC STATUS = UP, NNI PVC STATUS = ACTIVE
input pkts 0 output pkts 0 in bytes 0
out bytes 0 dropped pkts 100 in FECN pkts 0
in BECN pkts 0 out FECN pkts 0 out BECN pkts 0
in DE pkts 0 out DE pkts 0
out bcast pkts 0 out bcast bytes 0
switched pkts 0
Detailed packet drop counters:
no out intf 0 out intf down 100 no out PVC 0
in PVC down 0 out PVC down 0 pkt too big 0
pvc create time 00:25:32, last time pvc status changed 00:06:31
Configuring QoS Features
For information about configuring QoS features on the Cisco 10000 series router, see the Cisco 10000
Series Router Quality of Service Configuration Guide.
Table 20-4 and Table 20-5 outline the level of support for modular QoS CLI (MQC) commands as they
relate to Frame Relay DLCI interfaces.