user manual

Configuring Data-Link Switching Plus
DLSw+ Configuration Examples
BC-322
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
interface fddi 0
no ip address
source-bridge 26 1 10
source-bridge spanning
Router B
source-bridge ring-group 10
dlsw local peer peer-id 132.11.11.3
dlsw remote-peer 0 tcp 132.11.11.2
interface loopback 0
ip address 132.11.11.3 255.255.255.0
interface tokenring 0
no ip address
source-bridge 25 1 10
source-bridge spanning
DLSw+ Translation Between SDLC and Token Ring Media Example
DLSw+ provides media conversion between local or remote LANs and SDLC. For additional
information about configuring SDLC parameters, refer to the chapter “Configuring LLC2 and SDLC
Parameters.”
Figure 137 illustrates DLSw+ with SDLC encapsulation. For this example, 4000.1020.1000 is the MAC
address of the FEP host (PU 4.0). The MAC address of the AS/400 host is 1000.5aed.1f53, which is
defined as Node Type 2.1. Router B serves as the primary station for the remote secondary station 01.
Router B can serve as either primary station or secondary station to remote station D2.
Figure 137 DLSw+ Translation Between SDLC and Token Ring Media
Router A
hostname Router A
!
source-bridge ring-group 2000
dlsw local-peer peer-id 150.150.10.2
dlsw remote-peer 0 tcp 150.150.10.1
FEP
Token
Ring
400
Token
Ring
100
Token
Ring
500
1000.5aed.1F53
4000.1020.1000
51863
S0
S2 S1
S8
Router A
Router B
PU type 2.1
sdlc address
D2
PU type 2.0
sdlc address
01
AS/400