user manual

Configuring Data-Link Switching Plus
DLSw+ Configuration Examples
BC-320
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
Router A
source-bridge ring-group 1111
dlsw local-peer peer-id 10.2.2.2
dlsw remote-peer 0 tcp 10.1.1.1
interface loopback 0
ip address 10.2.2.2 255.255.255.0
interface TokenRing 0
no ip address
ring-speed 16
source-bridge 2 1111
source-bridge spanning
Router B
dlsw local-peer peer-id 10.1.1.1
dlsw remote-peer 0 tcp 10.2.2.2
interface loopback 0
ip address 10.1.1.1 255.255.255.0
interface serial 0
mtu 4096
no ip address
encapsulation sdlc
no keepalive
nzri-encoding
clockrate 9600
sdlc vmac 4000.3745.0000
sdlc N1 48016
sdlc address 04 echo
sdlc partner 4000.1111.0020 04
sdlc dlsw 4
DLSw+ Translation Between Ethernet and Token Ring Configuration Example
DLSw+ also supports Ethernet media. The configuration is similar to other DLSw+ configurations,
except for configuring for a specific media. The following example shows Ethernet media (see
Figure 135).
Figure 135 DLSw+ Translation Between Ethernet and Token Ring
Router A
hostname Router A
!
dlsw local-peer peer-id 128.207.111.1
dlsw remote-peer 0 tcp 128.207.1.145
AS/400
128.207.111.1
S3584
e0
128.207.1.145
e1/2
Token
Ring
7
Router A
Router B