user manual

Configuring Data-Link Switching Plus
Verifying DLSw+
BC-310
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
Configuring DLSw+ Timers
To configure DLSw+ timers, use the following command in global configuration mode:
See the DLSw+ Design and Implementation Guide “Customization” chapter and the Cisco IOS Bridging
and IBM Networking Command Reference (Volume 1 of 2) for command details.
Verifying DLSw+
To verify that DLSw+ is configured on the router, use the following command in privileged EXEC mode:
The following sample shows that DLSw+ is configured on router milan:
milan#show dlsw capabilities local
DLSw:Capabilities for peer 1.1.1.6(2065)
vendor id (OUI) :'00C' (cisco)
version number :1
release number :0
init pacing window :20
unsupported saps :none
num of tcp sessions :1
loop prevent support :no
icanreach mac-exclusive :no
icanreach netbios-excl. :no
reachable mac addresses :none
reachable netbios names :none
cisco version number :1
peer group number :0
border peer capable :no
peer cost :3
biu-segment configured :no
UDP Unicast support :yes
local-ack configured :yes
priority configured :no
Cisco Internetwork Operating System Software IOS GS Software (GS7-K-M),
Experimental Version 11.1(10956) [sbales 139]
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Thu 30-May-96 09:12 by sbales8
If only a command prompt appears, then DLSw+ is not configured for the router.
Command Purpose
Router(config)# dlsw timer
{icannotreach-block-time | netbios-cache-timeout
| netbios-explorer-timeout | netbios-group-cache
|netbios-retry-interval |
netbios-verify-interval |sna-cache-timeout |
sna-explorer-timeout | sna-group-cache |
sna-retry-interval | sna-verify-interval} time
Configures DLSw+ timers.
Command Purpose
Router# show dlsw capabilities local
Displays the DLSw+ configuration of a specific peer.