user manual

4-17
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Chapter 4 Installing Hardware Options
Completing the Installation
Installing the Content Engine Cover and Bezel
Complete the following steps to install the Content Engine cover and bezel:
Step 1 Install the cover by placing it into position and sliding it forward. Then tighten
the captive screws (labeled 1 in Figure 4-7).
Caution Before sliding the cover forward, make sure that the cover will properly engage
the ledge at the front of the Content Engine.
Step 2 Install the bezel.
a. Align the hooks on the bottom of the bezel with the Content Engine.
b. Press the bezel toward the Content Engine until it clicks into place.