user manual

4-5
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Chapter 4 Installing Hardware Options
Installing Adapters
Installing an MPEG Decoder Adapter
Complete the following steps to install an MPEG decoder adapter.
Note The illustrations in this document might differ slightly from your hardware.
Step 1 Review the safety information in the “Safety Guidelines” section on page 2-4.
Step 2 Power down the Content Engine and peripheral devices.
Step 3 Disconnect the power cord and then all external cables from the Content Engine.
Step 4 Remove the Content Engine cover.
Note It might be easier to route the cables before you install the adapter.
Step 5 Loosen the captive screw (labeled 4 in Figure 4-3) located on the rear of the
Content Engine adjacent to PCI-X slot 1 and remove the expansion slot cover.
Note PCI expansion slot covers must be installed on all vacant slots. This
maintains the electronic emissions characteristics of the Content Engine
and ensures proper cooling of Content Engine components.