user manual

3-13
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Chapter 3 Installing the Content Engine
Connecting Power and Booting the System
Figure 3-9 CE-511 and CE-566 Back Panel Ports and Receptacles
Note Cisco ACNS software does not support the use of a keyboard or mouse (PS/2 or
USB) with the Content Engine. However, keyboard and mouse are supported by
the BIOS for power-on self-test (POST), and the configuration/setup utility.
Connecting Power and Booting the System
Follow these steps to connect power to the Content Engine:
Step 1 Review the information in the “Safety Warnings” section on page 2-1.
Step 2 Plug the AC power cord into the power cord receptacle at the rear of the
Content Engine. (See Figure 3-9.)
Step 3 Connect the other end of the power cord to a power source at your installation site.
1 AC power receptacle 2 Mouse connector
3 Keyboard connector 4 Ethernet 1 receptacle
5 Ethernet 2 receptacle 6 USB ports (not supported)
7 Video connector 8 Serial connector
115773
1 2 3 4
8 7 5
6