user manual
Table Of Contents
- Cisco Content Engine 511 and 566 Hardware Installation Guide
- Contents
- Preface
- Introducing the Content Engine
- Preparing to Install the Content Engine
- Installing the Content Engine
- Installing Hardware Options
- Troubleshooting the System Hardware
- Maintaining the Content Engine
- Index
Chapter 3 Installing the Content Engine
Installing a CE-511 or CE-566 Unit
3-10
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Step 6 Align and insert the inner slide rails into the slide rail assemblies until they lock
into place.
Step 7 Slide the Content Engine into the rack until the Content Engine locks into place.
Step 8 Tighten the captive screw (labeled 1 in Figure 3-8) on each side of the front of the
Content Engine to secure the Content Engine to the rack.
Figure 3-8 Inserting the Inner Slide Rails
Step 9
Attach the power cords and the Ethernet cables to the Content Engine.
Because the Content Engine does not contain cable retention brackets or cable
strain relief brackets, you must first bundle the external cables before you
route them.
83201
1