user manual
Table Of Contents
- Cisco Active Network Abstraction Fault Management User Guide Version 3.6 Service Pack 1
- Contents
- About This Guide
- Fault Management Overview
- Fault Detection and Isolation
- CiscoANA Event Correlation and Suppression
- Advanced Correlation Scenarios
- Device Unreachable Alarm
- IP Interface Failure Scenarios
- Multi Route Correlation
- Generic Routing Encapsulation (GRE) Tunnel Down/Up
- BGP Process Down Alarm
- MPLS Interface Removed Alarm
- LDP Neighbor Down Alarm
- Correlation Over Unmanaged Segments
- Event and Alarm Configuration Parameters
- Impact Analysis
- Supported Service Alarms
- Event and Alarm Correlation Flow
Contents
v
Cisco Active Network Abstraction Fault Management User Guide, Version 3.6 Service Pack 1
OL-14284-01
CHAPTER
5 Correlation Over Unmanaged Segments 5-1
Cloud VNE 5-1
Types of Unmanaged Networks Supported 5-1
Fault Correlation Across the Frame Relay or ATM or Ethernet Cloud 5-2
Cloud Problem Alarm 5-3
Cloud Correlation Example 5-3
CHAPTER
6 Event and Alarm Configuration Parameters 6-1
Alarm Type Definition 6-1
Event (Sub-Type) Configuration Parameters 6-2
General Event Parameters 6-2
Root Cause Configuration Parameters 6-2
Correlation Configuration Parameters 6-3
Network Correlation Parameters 6-3
Flapping Event Definitions Parameters 6-4
System Correlation Configuration Parameters 6-4
CHAPTER
7 Impact Analysis 7-1
Impact Analysis Options 7-1
Impact Report Structure 7-2
Affected Severities 7-2
Impact Analysis GUI 7-3
Affected Parties Tab 7-3
Viewing a Detailed Report For the Affected Pair 7-4
Disabling Impact Analysis 7-6
Accumulating Affected Parties 7-6
Accumulating the Affected Parties In an Alarm 7-7
Accumulating the Affected Parties In the Correlation Tree 7-7
Updating Affected Severity Over Time 7-7
APPENDIX
A Supported Service Alarms A-1
Shelf Out A-4
Rx Dormant A-5
Tx Dormant A-5
Link Over Utilized A-5