user manual

3-4

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-8370-04

Chapter 3 Mounting Instructions

Mounting Below a Suspended Ceiling

Note To comply with NEC code, a #10-24 grounding lug is provided on the mounting bracket.

You should review Figu

re 3-2 before beginning the mounting process.

Figure 3-2 Mounting Bracket Parts

Follow these steps to mount your access point on a suspended ceiling:

Step 1 Decide where you want to mount the access point.

Step 2 Attach two T-rail clips to the suspended ceiling T-rail.

Step 3 Use the mounting bracket to adjust the distance between the T-rail clips so that they align with the holes

in the mounting bracket.

Step 4 Use a standard screwdriver to tighten the T-rail clip studs in place on the suspended ceiling T-rail. Do

not overtighten.

Step 5 Install a plastic spacer on each T-rail clip stud. The spacer’s legs should contact the suspended ceiling

T-rail.

Step 6 Attach the mounting bracket to the T-rail clip studs and start a Keps nut on each stud.

1 Suspended ceiling T-rail 4 Mounting bracket

2 T-rail clips 5 Keps nut (contains an attached lock washer)

3 Plastic spacer

74121