User's Manual

Send document comments to [e-mail]
3-16
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 3 Installing a Cisco Nexus 7018 Chassis
Installing the Cable Management Assemblies
Figure 3-9 Attaching the Upper Left Cable Management Assembly to the Left Rack-Mount
Brackets
Step 3 Repeat Step 1 and Step 2 to loosely attach a lower cable management assembly and an upper cable
management assembly to the right rack-mount bracket. When completed, the chassis will appear as
shown in
Figure 3-10.
1 Upper cable management assembly 2 Left rack-mount bracket
3 Position the assembly so that the two upper
hooks on the rack-mount bracket fit inside the
two holes on the assembly, and then slide the
assembly down so that it is held by the hooks.
4 Loosely fasten the assembly to the
rack-mount bracket with four M4x10 screws.
Do not tighten these screws.
2
1
4
3
3
192182