User's Manual

Enabling the Error-Disabled Recovery
You can specify the application to bring the interface out of the error-disabled (err-disabled) state and retry
coming up. It retries after 300 seconds, unless you configure the recovery timer (see the errdisable recovery
interval command).
Procedure
PurposeCommand or Action
Enters configuration mode.config t
Example:
switch#config t
switch(config)#
Step 1
Specifies a condition under which the interface
automatically recovers from the err-disabled
errdisable recovery cause {all | udld |
bpduguard | link-flap | failed-port-state |
pause-rate-limit}
Step 2
state, and the device retries bringing the
interface up. The device waits 300 seconds to
retry. The default is disabled.
Example:
switch(config)#errdisable recovery cause
all
switch(config-if)#
Displays information about err-disabled
interfaces.
show interface status err-disabled
Example:
switch(config)#show interface status
err-disabled
Step 3
(Optional) Copies the running configuration to
the startup configuration.
copy running-config startup-config
Example:
switch(config)#copy running-config
startup-config
Step 4
This example shows how to enable err-disabled recovery under all conditions:
switch(config)#errdisable recovery cause all
switch(config)#
Configuring the Error-Disabled Recovery Interval
You can use this procedure to configure the err-disabled recovery timer value. The range is from 30 to 65535
seconds. The default is 300 seconds.
Cisco Nexus 3000 NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U3(1)
OL-26590-01 19
Configuring Ethernet Interfaces
Enabling the Error-Disabled Recovery