User's Manual

DCBXP is enabled by default, provided LLDP is enabled. When LLDP is enabled, DCBXP can be enabled
or disabled using the [no] lldp tlv-select dcbxp command. DCBXP is disabled on ports where LLDP transmit
or receive is disabled.
To configure LLDP settings, perform this task:
Before You Begin
Ensure that the LLDP feature is enabled on the switch.
Procedure
PurposeCommand or Action
Enters configuration mode.switch# configure terminal
Step 1
Configures LLDP options.switch(config)# lldp {holdtime
seconds | reinit seconds | timer
Step 2
Use the holdtime option to set the length of time (10 to 255
seconds) that a device should save LLDP information received
before discarding it. The default value is 120 seconds.
seconds | tlv-select {dcbxp |
management-address |
port-description | port-vlan |
Use the reinit option to set the length of time (1 to 10 seconds)
to wait before performing LLDP initialization on any interface.
The default value is 2 seconds.
system-capabilities |
system-description |
system-name}}
Use the timer option to set the rate (5 to 254 seconds) at which
LLDP packets are sent. The default value is 30 seconds.
Use the tlv-select option to specify the type length value (TLV).
The default is enabled to send and receive all TLVs.
Use the dcbxp option to specify the Data Center Ethernet
Parameter Exchange (DCBXP) TLV messages.
Use the managment-address option to specify the management
address TLV messages.
Use the port-description option to specify the port description
TLV messages.
Use the port-vlan option to specify the port VLAN ID TLV
messages.
Use the system-capabilities option to specify the system
capabilities TLV messages.
Use the system-description option to specify the system
description TLV messages.
Use the system-name option to specify the system name TLV
messages.
Reset the LLDP values to their defaults.switch(config)# no lldp
{holdtime | reinit | timer}
Step 3
Displays LLDP configurations.(Optional)switch#show lldp
Step 4
Cisco Nexus 3000 NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U3(1)
128 OL-26590-01
Configuring LLDP
Configuring Global LLDP Commands