Network Router User Manual

4-2
Cisco ONS 15454 SDH Procedure Guide, R4.6
January 2004
Chapter 4 Turn Up Node
NTP-D24 Verify Card Installation
8. NTP-D170 Create Protection Groups, page 4-26—Complete this procedure, as needed, to set up 1:1,
1:N, 1+1, or Y-cable protection groups for ONS 15454 SDH electrical and optical cards. If you are
turning up a DWDM or hybrid node, do not complete this procedure until directed to do so in
Chapter 5, “Turn Up a DWDM Node.”
9. NTP-D34 Set Up SNMP, page 4-32—Complete this procedure if simple network management
protocol (SNMP) will be used for network monitoring.
NTP-D24 Verify Card Installation
Step 1 Verify that two TCC2 cards are installed in Slots 7 and 11.
Step 2 Verify that the green ACT (active) LED is illuminated on one TCC2 and the amber STBY (standby) LED
is illuminated on the second TCC2.
Note If the TCC2 cards are not installed, or if their LEDs are not operating as described, do not
proceed. Repeat the “DLP-D332 Install the TCC2 Cards” task on page 2-7, or refer to the
Cisco ONS 15454 SDH Troubleshooting Guide to resolve installation problems before
proceeding to Step 3.
If you are provisioning the ONS 15454 for DWDM only, continue with Step 16. Otherwise, continue
with the next step.
Step 3 Verify that cross-connect cards (XC10G, XC-VXL-2.5G, or XC-VXL-10G) are installed in Slots 8 and
10. The cross-connect cards must be the same type.
Step 4 Verify that the green ACT (active) LED is illuminated on one cross-connect card and the amber STBY
(standby) LED is illuminated on the second cross-connect card.
Note If the cross-connect cards are not installed, or if their LEDs are not illuminated as described, do
not proceed. Repeat the “DLP-D333 Install the XC10G, XCVXL 10G, or XCVXL 2.5G Cards”
task on page 2-9, or refer to the Cisco ONS 15454 SDH Troubleshooting Manual to resolve
installation problems before proceeding to Step 5.
If you are provisioning the ONS 15454 for DWDM and TDM (hybrid node), continue with Step 16.
Otherwise, continue with the next step.
Step 5 If your site plan requires an AIC-I card, verify that the AIC-I card is installed in Slot 9 and its ACT
(active) LED displays a solid green light.
Purpose This procedure verifies that the ONS 15454 SDH node is ready for turn up.
Tools/Equipment An engineering work order, site plan, or other document specifying the
ONS 15454 SDH card installation.
Prerequisite Procedures Chapter 1, “Install the Shelf and FMECs”
Chapter 2, “Install Cards and Fiber-Optic Cable”
Required/As Needed Required
Onsite/Remote Onsite
Security Level Retrieve or higher