Computer Hardware User Manual
Table Of Contents
- Command Reference
- Supervisor Console Commands
- Processor Control Commands
- MWAM Console Commands
- Command Details
- mwam module allowed-vlan
- mwam module vlan-based
- session slot
- show mwam module
- mwam bootflash access
- logging listen mwam
- execute-on
- mwam module cpu logging
- show logging
- clear logging slot
- show processor
- show log
- reload
- recover-ios
- normal-ios
- show images
- restore
- show tech-support
- show version
- mwam config-mode
- show mwam config-mode
- logging main-cpu
- show mwam
6-2
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Processor Control Commands
Processor Control Commands
The Processor Control (PC) commands are available when you session into MWAM processor 1 from
the Supervisor console. The PC commands provide various functions for MWAM processors.
To access the PC commands, use the session slot command to establish a connection to processor 1.
Then log into the PC as root user with the password cisco.
• show processor
• show log
• show tech-support
• show version
• show images
• reload
• recover-ios
• normal-ios
• restore
MWAM Console Commands
The following commands are available at the MWAM console:
• mwam config-mode
• show mwam config-mode
• logging main-cpu
• show mwam