Computer Hardware User Manual
Table Of Contents
- Command Reference
- Supervisor Console Commands
- Processor Control Commands
- MWAM Console Commands
- Command Details
- mwam module allowed-vlan
- mwam module vlan-based
- session slot
- show mwam module
- mwam bootflash access
- logging listen mwam
- execute-on
- mwam module cpu logging
- show logging
- clear logging slot
- show processor
- show log
- reload
- recover-ios
- normal-ios
- show images
- restore
- show tech-support
- show version
- mwam config-mode
- show mwam config-mode
- logging main-cpu
- show mwam
6-12
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Command Details
The port numbering pattern is important if you are configuring other UDP ports on either the Supervisor
or the MWAM processor.
Examples The following example illustrates the logging listen mwam command:
router(config)# logging listen mwam 4100
MWAM Processor: 2 3 4 5 6
Base UDP Port:
1
1. Must be in the range 4000-10000 and be a multiple of 100.
<40-100>00 <40-100>00 <40-100>00 <40-100>00 <40-100>00
Additional UDP Port: <40-100>02 <40-100>03 <40-100>04 <40-100>05 <40-100>06
Additional UDP Port: <40-100>12 <40-100>13 <40-100>14 <40-100>15 <40-100>16