Computer Hardware User Manual
Table Of Contents
- Command Reference
- Supervisor Console Commands
- Processor Control Commands
- MWAM Console Commands
- Command Details
- mwam module allowed-vlan
- mwam module vlan-based
- session slot
- show mwam module
- mwam bootflash access
- logging listen mwam
- execute-on
- mwam module cpu logging
- show logging
- clear logging slot
- show processor
- show log
- reload
- recover-ios
- normal-ios
- show images
- restore
- show tech-support
- show version
- mwam config-mode
- show mwam config-mode
- logging main-cpu
- show mwam
6-10
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Command Details
mwam bootflash access
Note The MWAM bootflash access must be enabled if you want to operate in Supervisor mode.
To enable file transfer requests between the Supervisor bootflash and the individual processors on the
MWAM, use the mwam bootflash access command in configuration mode. To remove this
configuration, use the no form of the command.
mwam bootflash access
no mwam bootflash access
Syntax Description
Defaults MWAM bootflash access is enabled by default. To disable access, issue no mwam bootflash access.
Command Modes Configuration
Command History
Usage Guidelines Use the no form of this command to disable MWAM access to the Supervisor bootflash.
Examples The following example illustrates the mwam bootflash access command:
Sup-7606(config)# mwam bootflash access
mwam bootflash
access
Configures bootflash access for MWAM file transfer requests.
Release Modification
12.2(14)ZA4 This command was introduced.