Switch User's Manual
Table Of Contents
- Regulatory Compliance and Safety Information for the Cisco ME 6500 Series Ethernet Switch
- Translated Safety Warnings
- Statement 17-Overtemperature Warning
- Statement 37-Restricted Area Warning
- Statement 39-Grounded Equipment Warning
- Statement 43-Jewelry Removal Warning
- tatement 48-Stacking the Chassis Warning
- Statement 148-Installation Warning
- Statement 171-Ethernet Cable Shielding in Offices
- Statement 258-Fan Tray Removal Warning
- Statement 322-DC Power Off Warning
- Statement 1001-Work During Lightning Activity
- Statement 1004-Installation Instructions
- Statement 1006-Chassis Warning for Rack-Mounting and Servicing
- Statement 1008-Class 1 Laser Product
- Statement 1012-Laser Beam Exposure
- Statement 1017-Restricted Area
- Statement 1030-Equipment Installation
- Statement 1040-Product Disposal
- Statement 1045-Short-Circuit Protection
- Statement 1046-Installing or Replacing the Unit
- Statement 1051-Laser Radiation
- Statement 1074-Comply with Local and National Electrical Codes
- Statement 1075-Hazardous Voltage or Energy Present on DC Power Terminals
- European Directives
- California Perchlorate Contamination Prevention Act (Title 22, California Code of Regulations, Chapter 33)
- Standards Compliance
- EMC Environmental Conditions for Products Installed in the European Union
- EMC Class A Notices and Warnings
- Optional Cautions
- Obtaining Documentation
- Documentation Feedback
- Cisco Product Security Overview
- Product Alerts and Field Notices
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Translated Safety Warnings

9
Regulatory Compliance and Safety Information for the Cisco ME 6500 Series Ethernet Switch
78-17361-02
Translated Safety Warnings
Statement 258—Fan Tray Removal Warning
Warning
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
fan blades completely stop before you remove the fan tray.
Waarschuwing
Houd tijdens het verwijderen van de ventilator de handen en vingers uit de buurt van de draaiende
ventilatorschoepen. Laat de ventilatorschoepen volledig tot stilstand komen alvorens de ventilator
te verwijderen.
Varoitus
Pidä kädet ja sormet pois tuulettimen pyörivistä siivistä tuuletinalustaa poistaessasi. Anna
tuulettimen siipien pysähtyä kokonaan ennen kuin irrotat tuuletinalustan.
Attention
Lors du retrait du plateau du ventilateur, veillez à ce que vos mains et doigts restent à l’écart des
pales en rotation du ventilateur. Attendez que les pales du ventilateur soient parvenues à une
immobilité complète avant de retirer le plateau du ventilateur.
Warnung
Beim Herausnehmen des Lüfterkastens Hände und Finger von den sich drehenden Gebläseflügeln
fern halten. Vor Herausnehmen des Gebläsekastens warten, bis die Gebläseflügel völlig zum
Stillstand gekommen sind.
Avvertenza
Quando si toglie il vano della ventola, fare attenzione che le mani e le dita non vengano in contatto
con la ventola in movimento. Attendere che la ventola si fermi completamente prima di togliere il
vano.
Advarsel
Når du fjerner viftedekselet, hold hender og fingre borte fra de roterende viftebladene. La
viftebladene stanse helt før du fjerner viftedekselet.
Aviso
Mantenha as suas mãos e dedos afastados das lâminas em movimento da ventoinha, ao retirar a
respectiva bandeja. Deixe as lâminas da ventoinha parar completamente antes de retirar a bandeja.
¡Advertencia!
Cuando quite la bandeja del abanico, mantenga las manos y los dedos alejados de las aspas en
movimiento. Deje que las aspas se detengan completamente antes de quitar la bandeja del abanico.
Varning!
Håll händer och fingrar borta från de roterande fläktbladen när du tar av fläktskyddet. Låt fläkten
stanna helt innan du tar av fläktskyddet.