Switch User's Manual
Table Of Contents
- Regulatory Compliance and Safety Information for the Cisco ME 6500 Series Ethernet Switch
- Translated Safety Warnings
- Statement 17-Overtemperature Warning
- Statement 37-Restricted Area Warning
- Statement 39-Grounded Equipment Warning
- Statement 43-Jewelry Removal Warning
- tatement 48-Stacking the Chassis Warning
- Statement 148-Installation Warning
- Statement 171-Ethernet Cable Shielding in Offices
- Statement 258-Fan Tray Removal Warning
- Statement 322-DC Power Off Warning
- Statement 1001-Work During Lightning Activity
- Statement 1004-Installation Instructions
- Statement 1006-Chassis Warning for Rack-Mounting and Servicing
- Statement 1008-Class 1 Laser Product
- Statement 1012-Laser Beam Exposure
- Statement 1017-Restricted Area
- Statement 1030-Equipment Installation
- Statement 1040-Product Disposal
- Statement 1045-Short-Circuit Protection
- Statement 1046-Installing or Replacing the Unit
- Statement 1051-Laser Radiation
- Statement 1074-Comply with Local and National Electrical Codes
- Statement 1075-Hazardous Voltage or Energy Present on DC Power Terminals
- European Directives
- California Perchlorate Contamination Prevention Act (Title 22, California Code of Regulations, Chapter 33)
- Standards Compliance
- EMC Environmental Conditions for Products Installed in the European Union
- EMC Class A Notices and Warnings
- Optional Cautions
- Obtaining Documentation
- Documentation Feedback
- Cisco Product Security Overview
- Product Alerts and Field Notices
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Translated Safety Warnings
39
Regulatory Compliance and Safety Information for the Cisco ME 6500 Series Ethernet Switch
78-17361-02
EMC Class A Notices and Warnings
Statement 256—Class A Warning for Hungary
Statement 294—Class A Warning for Korea
Warning
This equipment is a class A product and should be used and installed properly according to the
Hungarian EMC Class A requirements (MSZEN55022). Class A equipment is designed for typical
commercial establishments for which special conditions of installation and protection distance are
used.
Warning
This is a Class A Device and is registered for EMC requirements for industrial use. The seller or
buyer should be aware of this. If this type was sold or purchased by mistake, it should be replaced
with a residential-use type.