User Guide

viii
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
OL-7677-04
Preface
Conventions
Appendix A, “Connector and Cable Specifications,” describes the connectors, cables, and adapters that
can be used to connect to the switch.
Appendix B, “Technical Specifications,” lists the physical and environmental specifications for the
switches and the regulatory agency approvals.
Appendix C, “Connecting to DC Power”describes how to connect the Cisco ME switch to a direct
current (DC)-input power source.
Appendix D, “Configuring the Switch with the CLI-Based Setup Program,” has an installation and setup
procedure for a standalone switch.
Conventions
This document uses these conventions and symbols for notes, cautions, and warnings:
Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in
this manual.
Caution Means reader be careful. In this situation, you might do something that could result in equipment
damage or loss of data.
The safety warnings for this product are translated into several languages in the Regulatory Compliance
and Safety Information for the Cisco ME 3400 and ME 2400 Ethernet Access Switches that ships with
the product. The EMC regulatory statements are also included in that guide.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device.
Statement 1071
SAVE THESE INSTRUCTIONS