Network Device Installation Guide

Send documentation comments to [e-mail].
D-6
Cisco MDS 9500 Series Hardware Installation Guide
OL-17467-02
Appendix D Technical Specifications
Power Specifications for the Cisco MDS 9513 Director
Table D-7 lists the specifications for the batteries on the Cisco MDS 9000 Family caching services
module.
Note The CSM does not support Cisco SAN-OS Release 3.0(1).
Power Specifications for the Cisco MDS 9513 Director
This section includes the following topics:
• Specifications for the Cisco MDS 9513 Power Supplies, page D-6
• Component Power Requirements and Heat Dissipation for the Cisco MDS 9513 Director, page D-7
• AC Power Consumption for the Cisco MDS 9513 Director, page D-8
Specifications for the Cisco MDS 9513 Power Supplies
The 6000-W AC power supply provides power based upon the input voltage. Each power supply has two
AC power connections and will provide power as follows:
• One AC power connection @110 VAC = No output
• Two AC power connection @110 VAC = 2900 W output
• One AC power connection @ 220 VAC = 2900 W output
• One AC power connection @110 VAC and one AC power connection @ 220 VAC = 2900 W output
Crossbar module fan tray 2.25 lb (1.13 kg)
Module blank panels 0.50 lb (0.25 kg)
Table D-6 Weight of Modules in the Cisco MDS 9000 Family (continued)
Module Weight
Ta b l e D-7 Caching Services Module Battery Specifications
Attribute Value
Nominal voltage 9.6 V
Rated capacity Typical discharge capacity at 0.2C rate: 2100 mAh
Minimum discharge capacity at 0.2C rate: 2000 mAh
Minimum discharge capacity at 5C rate: 1800 mAh
(1 V/cell discharge cut-off)
Discharge The battery is capable of continuous discharge from
41 to 140°F (5 to 60°C) at 5C-rate
Charge From 32 to 59°F (0 to 15°C) at C/10 rate and from 59
to 104°F (15 to 40°C) at C/2 rate
Storage temperature 32 to 95°F (0 to +35°C)
Relative humidity range From 5 to 90%