Network Device Installation Guide

Send documentation comments to [e-mail].
2-78
Cisco MDS 9500 Series Hardware Installation Guide
OL-17467-02
Chapter 2 Installing the Cisco MDS 9500 Series
Removing and Installing Clock Modules
Note Note the position and orientation of the clock module before you remove it from the director
chassis because you must install the new clock module in the same position.
Step 3 Verify the LEDs on the clock modules.
Step 4 Disconnect and gently remove the module, placing it on an antistatic mat or foam. (See Figure 2-41.)
Figure 2-41 Clock Module Replacement on the Cisco MDS 9513 Director (Rear View)
Step 5 Repeat Step 3 and Step 4 to remove any additional clock modules.
144602
Component
side
Sheet metal
side