Network Device Installation Guide

Send documentation comments to [e-mail].
2-42
Cisco MDS 9500 Series Hardware Installation Guide
OL-17467-02
Chapter 2 Installing the Cisco MDS 9500 Series
Removing, Installing, and Verifying Supervisor, Switching, and Services Modules
Figure 2-23 Clearing the EMI Gasket
b. Grasp the two ejector levers using the thumb and forefinger of each hand, and press down to create
a small 0.040-inch (1-mm) gap between the module’s EMI gasket and the module above it. (See
Figure 2-24.)
91690
1mm
Amount of gap
between the
module EMI
gasket and the
module above it
5
4
6
SWITCH FABIRD MDL
WS-C6500-SFM
Press down gently
Press down gently