User Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Basic Set Up
- Viewing Live Video
- Advanced Viewing Set Up
- Managing an IP Camera through the Web
- Connecting to an IP Camera
- Basic Setup Window
- Advanced Setup Window
- IP Filter Window
- Users Window
- Maintenance Window
- Firmware Window
- Video Window
- Audio Window
- Mail Window
- Motion Detection Window
- Event Window
- SNMP Window
- DDNS Window
- I/O Ports Window
- RS-485 Window
- System Window
- Image Window
- Network Window
- Syslog & Log Window
- View Video Log Window
- Troubleshooting
- Streaming Video/Audio Solution
- Index
EFT DRAFT—CISCO CONFIDENTIAL
1-3
Cisco Video Surveillance IP Camera User Guide
OL-14220-01
Chapter 1 Introduction
Physical Details
• WEP support—Full WEP support (64/128 Bit) on the wireless interface is provided.
• WPA/WPA2 support—The WPA/WPA2 standard is supported, allowing advanced encryption of
wireless data.
Physical Details
Table 1-1 describes the physical details of the IP camera.
Table 1-1 IP Camera Physical Details
Item Description
Front of Camera
CS mount lens The camera uses a standard video surveillance CS
mount lens. Ensure that the lens is clean. Any dirt
may degrade the image quality.
Microphone There is a connection for an external microphone
on the rear of the device.
Ready LED (amber) On—Power on.
Off—No power.
Blinking—Starting up. This process takes 15 to 20
seconds.
Active LED (green) Off—No user is viewing the camera.
Blinking—One or more user is viewing the camera
Rear of Camera
Antenna Attach the supplied antennas here. The antennas
are adjustable.