User Manual

EFT DRAFT—CISCO CONFIDENTIAL
5-15
Cisco Video Surveillance System IP Camera User Guide
OL-14220-01
Chapter 5 Managing an IP Camera through the Web
RS-485 Window
RS-485 Window
The RS-485 window allows you to configure the RS-485 protocol for the camera. To access this window,
connect to the camera as described in the “Connecting to an IP Camera” section on page 5-2 and then
choose Applications > RS-485.
Table 5-16 describes the options in the RS-485 window.
Table 5-15 I.O Ports Window Options
Option Description
Input Ports
Current State Indicates the current state of the input port. When the configured state
occurs, the event actions are triggered.
Triggered When Select the desired state:
• High
• Low
Output Ports
Current State Indicates the current state of the output port.
Default State Select the desired option from the drop-down list.
Output State If an event happens the alert is triggered.
Action Definition Select the option to control the output state.
Table 5-16 RS-485 Window Options
Option Description
RS-485
Enable RS-485 Check this check box to enable RS-485.
Baud Rate Select the Baud rate.
Date Bits Select the date bits.
Parity Select the parity type.
Stop Bits Select the stop bits.
Address Enter the value for the address.
Preset Position
Set Preset Position Click this button to define the preset point position.
Define positions in the Pan/Tilt window as described in the “Pan/Tilt
Window” section on page 5-16.