User Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Basic Set Up
- Viewing Live Video
- Advanced Viewing Set Up
- Managing an IP Camera through the Web
- Connecting to an IP Camera
- Basic Setup Window
- Advanced Setup Window
- IP Filter Window
- Users Window
- Maintenance Window
- Firmware Window
- Video Window
- Audio Window
- Mail Window
- Motion Detection Window
- Event Window
- SNMP Window
- DDNS Window
- I/O Ports Window
- RS-485 Window
- System Window
- Image Window
- Network Window
- Syslog & Log Window
- View Video Log Window
- Troubleshooting
- Streaming Video/Audio Solution
- Index
CHAPTER
EFT DRAFT—CISCO CONFIDENTIAL
5-1
Cisco Video Surveillance System IP Camera User Guide
OL-14220-01
5
Managing an IP Camera through the Web
This Chapter provides information about configuring an IP camera through the web-based interface. This
information is intended for the camera Administrator.
To configure a camera in this way, the camera must have an IP address that is compatible with your PC.
To configure this IP address, use the supplied Windows-based Wizard, as described in Chapter 2, “Basic
Set Up.”
This chapter includes these topics:
• Connecting to an IP Camera, page 5-2
• Basic Setup Window, page 5-3
• Advanced Setup Window, page 5-6
• IP Filter Window, page 5-8
• Users Window, page 5-8
• Maintenance Window, page 5-9
• Firmware Window, page 5-9
• Video Window, page 5-10
• Audio Window, page 5-11
• Mail Window, page 5-11
• Motion Detection Window, page 5-12
• Event Window, page 5-12
• SNMP Window, page 5-13
• DDNS Window, page 5-14
• I/O Ports Window, page 5-14
• RS-485 Window, page 5-15
• System Window, page 5-16
• Image Window, page 5-17
• Network Window, page 5-17
• Syslog & Log Window, page 5-18
• View Video Log Window, page 5-18