User Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Basic Set Up
- Viewing Live Video
- Advanced Viewing Set Up
- Managing an IP Camera through the Web
- Connecting to an IP Camera
- Basic Setup Window
- Advanced Setup Window
- IP Filter Window
- Users Window
- Maintenance Window
- Firmware Window
- Video Window
- Audio Window
- Mail Window
- Motion Detection Window
- Event Window
- SNMP Window
- DDNS Window
- I/O Ports Window
- RS-485 Window
- System Window
- Image Window
- Network Window
- Syslog & Log Window
- View Video Log Window
- Troubleshooting
- Streaming Video/Audio Solution
- Index
CHAPTER
EFT DRAFT—CISCO CONFIDENTIAL
2-1
Cisco Video Surveillance System IP Camera User Guide
OL-14220-01
2
Basic Set Up
This chapter provides instructions for installing and performing the initial setup of the IP camera.
This chapter includes these topics:
• System Requirements, page 2-1
• Installing the IP Camera, page 2-1
• Performing the Initial Set Up of the IP Camera, page 2-2
System Requirements
To use the wired LAN interface, a standard 10/100BaseT hub or switch and network cable is required.
To use the wireless interface on the IP camera, other wireless devices must be compliant with the
IEEE802.11b or IEEE802.11g specifications. All wireless stations must use compatible settings.
Note The default wireless settings are:
• Mode—Infrastructure
• ESSID—ANY
• Wireless Security—Disabled
• Domain—USA
• Channel No.—Auto
Installing the IP Camera
To install the IP camera, follow these steps:
Procedure
Step 1 Assemble the Camera
Screw the supplied antenna to the mounting point on the rear of the camera.