User's Manual

12-20
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-11350-01
Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection
Configuring WDS
Step 17 Browse to the System Configuration page, click Service Control, and restart ACS to apply your entries.
Figure 12-13 shows the System Configuration page.
Figure 12-13 ACS System Configuration Page
Configuring WDS Only Mode
WDS access points can operate in WDS only mode using the wlccp wds mode wds-only command.
After issuing this command and reloading, the access point starts working in the WDS only mode. In
WDS only mode, the dot11 subsystems are not initialized and the dot11 interface related commands
cannot be configured. In WDS only mode, the WDS supports up to 60 infrastructure access points and
up to 1200 clients. Use the no command to turn off WDS onlly mode. Use the show wlccp wds command
to display the working mode of the WDS access point.
To set the WDS access point to operate in both AP and WDS modes, use the no wlccp wds mode
wds-only command and use the write erase command to reload the access point immediately. After the
access point reloadss, the dot11 radio subsytems initialize. The access point and WDS associate directly
to wireless clients. In this mode, the WDS supports 30 infrastructure access points and 600 clients in
addition to 20 direct wireless client associations.