User's Manual

11-15
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-11350-01
Chapter 11 Configuring Authentication Types
Configuring Authentication Types
This example shows how to configure a pre-shared key for clients using WPA and static WEP, with group
key update options:
ap# configure terminal
ap(config-if)# ssid batman
ap(config-ssid)# wpa-psk ascii batmobile65
ap(config)# interface dot11radio 0
ap(config-ssid)# ssid batman
ap(config-if)# exit
ap(config)# broadcast-key vlan 87 membership-termination capability-change
Configuring MAC Authentication Caching
If MAC-authenticated clients on your wireless LAN roam frequently, you can enable a MAC
authentication cache on your access points. MAC authentication caching reduces overhead because the
access point authenticates devices in its MAC-address cache without sending the request to your
authentication server. When a client device completes MAC authentication to your authentication server,
the access point adds the client’s MAC address to the cache.
Beginning in privileged EXEC mode, follow these steps to enable MAC authentication caching:
Step 7
broadcast-key [ vlan vlan-id ]
{ change seconds }
[ membership-termination ]
[ capability-change ]
Use the broadcast key rotation command to configure
additional updates of the WPA group key.
Step 8
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
dot11 aaa mac-authen filter-cache
[timeout seconds]
Enable MAC authentication caching on the access point.
Use the timeout option to configure a timeout value for MAC
addresses in the cache. Enter a value from 30 to 65555 seconds.
The default value is 1800 (30 minutes). When you enter a
timeout value, MAC-authentication caching is enabled
automatically.
Step 3
exit Return to privileged EXEC mode.
Step 4
show dot11 aaa mac-authen
filter-cache [address]
Show entries in the MAC-authentication cache. Include client
MAC addresses to show entries for specific clients.
Step 5
clear dot11 aaa mac-authen
filter-cache [address]
Clear all entries in the cache. Include client MAC addresses to
clear specific clients from the cache.
Step 6
end Return to privileged EXEC mode.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.