Installation Guide

When removing this SFP assembly, you must proceed in the reverse order of this installation. Start

by loosening the cable gland’s nut.

Caution

Powering the Access Point over Power-over-Ethernet

The AP can be powered through Power-over-Ethernet (PoE) using the following:

• 802.3at (PoE+): Any 802.3at (30W) compliant switch port or Cisco Power Injector AIR-PWRINJ6=

• 802.3bt: Any 802.3bt compliant switch port or IEEE 802.3bt compliant Power Injector

• Cisco Universal PoE (Cisco UPOE)

If 802.3af is used, both the 2.4-GHz and 5-GHz radios are disabled, and Ethernet gets downgraded to 1 GbE

speeds. The SFP port and PoE-OUT is also disabled.

Note

Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide

Installation Overview

Powering the Access Point over Power-over-Ethernet