Installation Guide

Before you begin
Ensure that you have the following materials before beginning to mount the AP horizontally to a wall:
Table 8: Materials Needed for Mounting the AP using AIR-MNT-HORZ1= Kit
Supplied in the
Kit?
Materials Required
YesWall/Pole Mount L-Bracket
YesSolar Shield Cover
Yes(4) M6 x 12-mm Hex-head Bolts
Yes(2) Adjustable Band Clamps 2 to 5 inch (51 to 127 mm) Dia
Yes(4) 8-32 x 0.62” Phillips Pan Head Screw
No(4) wall screws and anchors (specified for wall material)
NoDrill bit for wall anchors
No10–mm box-end wrench or socket set
NoPhillips Screwdriver
Procedure
Step 1 Use the mounting bracket as a template to mark four screw hole locations on the mounting wall. See Figure
35: Wall mount L-bracket screw hole dimensions, on page 40 for the mounting bracket screw hole locations
and dimensions. See Figure 36: L-bracket AP mount dimensions, on page 41 for dimensions of the mounting
L-bracket.
Figure 35: Wall mount L-bracket screw hole dimensions
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
40
Installation Overview
Wall Mounting the AP with Horizontal Kit