Installation Guide

Figure 34: Pivoting Mounting Kit with Pole Mount Clamp
Pole mount screw clamp. It can fit poles having
a diameter of up to 2 to 3 inches (50 to 76 mm)
3One of four mounting holes for the AP. This is
the AP-plate end of the bracket and is fastened to
the back of the AP
1
One of four slots for band clamps.
This is the pivot bracket base plate and is fastened
to the pole.
Pole mount installation using band clamps are
shown in Figure 33: AP Pole Mounted Using the
Pivoting Mounting Bracket, on page 37.
2
Before you begin
Ensure that you have the following materials before beginning to mount the AP to a pole:
Table 7: Materials for Mounting the AP on a Pole using AIR-MNT-ART1= Kit
Supplied in the
Kit?
Materials Required
YesGround lug and screws (provided with the access point)
YesPivoting mount kit and hardware
Yes(8) M6 x 12-mm Hex-head Bolts
YesAdapter bracket for option horizontal mount
YesTwo stainless steel band clamps (adjustable 2 to 5 inch (51 to 127mm)
NoCrimping tool for ground lug, Panduit CT0720 with CD-720-1 die
NoFour wall mounting screws (6 mm max)
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
38
Installation Overview
Articulating Mount for the AP to a Pole