Installation Guide

Vertically Mounting the AP to a Pole
The AIR-MNT-VERT1= mounting kit contains a mounting bracket used for both wall mounting and pole
mounting. This kit can be used to install the AP on a pole or mast. It supports metal, wood, or fiberglass poles
of 2 to 5 inches (51 to 127 mm) in diameter.
Figure 27: AP Mounted on a Pole
One of four M6 keyhole slots for mounting the AP on the bracket.1
Top and bottom sets of band clamp slots for passing the clamps through.2
Top and bottom steel band clamps3
Pole (wood, metal, or fiberglass), 2 to 5 inch (51 to 127mm) diameter4
Before you begin
Ensure that you have the following materials before beginning to mount the AP to a pole:
Table 3: Materials Needed to Mount the AP on a Vertical Pole using AIR-MNT-VERT1= Kit
Supplied in the
Kit?
Materials Required
YesOne wall mount bracket
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
28
Installation Overview
Vertically Mounting the AP to a Pole