Cisco Systems Gigabit Switch Router Cisco 12008 : Gigabit Switch Router Installation and Configuration Guide : Page 246

Performing Other Configuration Tasks

Cisco 12008 Gigabit Switch Router Installation and Configuration Guide

4-62

To initiate the copy operation, issue the following command at the privileged

EXEC mode prompt:

Router# copy running-config slot0:myfile2

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet0):

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616

bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

Note In this example, the exclamation points (!!!) appear as the file is being

copied. The “C” characters signify the calculation of the CRC. The CRC verifies

that the file has been copied correctly.

Step 2 To further verify that the file was copied correctly, issue the directory command

at the privileged EXEC mode prompt:

Router# dir slot0:

-#- -length- -----date/time------ name

1 5200084 May 10 1997 19:24:12 gsr-p-mz.112-8

3 1215 May 10 1997 20:30:52 myfile1

4 6176844 May 10 1997 23:04:10 gsr-p-mz.112-8.1

5 1186 May 10 1997 16:56:50 myfile2

9197156 bytes available (11381148 bytes used)