User manual

Software Authentication Manager Commands on Cisco IOS XR Software
show sam sysinfo
SR-227
Cisco IOS XR System Security Command Reference
Related Commands
Table 21 show sam sysinfo Field Descriptions
Field Description
Status One of the following: running or not running.
If the SAM is not running, the System Manager should detect
that state and attempt to restart the SAM. If problems prevent the
System Manager from restarting the SAM after a predefined
number of repeated attempts, the SAM will not be restarted. In
such a case, you should contact Cisco Technical Assistance
Center (TAC) personnel.
Prompt Interval Current setting for the prompt interval. The interval can be set in
the range from 0 to 300 seconds. The value shown in the sample
output (10 seconds) is the default.
Prompt Default Response Current setting that specifies the action taken by the SAM if the
prompt interval expires before the user responds to the prompt.
If the user does not respond to the prompt, the SAM waits for the
specified interval to expire and then takes the action specified in
the sam prompt-interval command (either proceed or
terminate).
Entering the sam prompt-interval command with the proceed
keyword causes the show sam sysinfo command to display
“Yes,” meaning that the default action taken by the SAM is to
wait for the prompt interval to expire and then respond as if it had
received a “yes” from the user.
Entering the sam prompt-interval command with the terminate
keyword causes the show sam sysinfo command to display
“No,” meaning that the default action taken by the SAM is to wait
for the prompt interval to expire and then respond as if it had
received a “no” from the user.
Command Description
sam prompt-interval Sets the interval that the SAM waits after prompting the user for input when
it detects an abnormal condition and determines how the SAM responds
when it does not receive user input within the specified interval.