Basic Dial NMS Implementation Guide

ManualsBrandsCisco Systems ManualsNetwork RouterDial NMS

Table Of Contents

Preface
Overview of Basic SNMP Building Blocks
Network Design for a DialNMSCase Study
Dial MIBs and OIDs Used in the Case Study
Task 1—Enabling SNMP in a Cisco IOS Device
- About Enabling SNMP
  - Enabling SNMP
Task 2— Exploring SNMP Capabilities by Using UCD-SNMP
- About Using UCD-SNMP
  - Installing UCD-SNMP and Downloading Cisco MIBs
  - Exploring SNMP MIBs for Dial Networks
- About SNMP Commander
  - Setting Up SNMP Commander
Task 3—Using MRTG to Monitor and Graph Traffic Loads
Task 4—Using Syslog, NTP, and Modem Call Records to Isolate and Troubleshoot Faults
Task 5—Setting Up a Web Portal forthe DialNMS
- About a Web Portal
  - Building a Device Linker Web Page
  - Troubleshooting a Cisco 2511 Console Connection
- About HTTP Access to the CLI
  - Using HTTP to Access CLI Commands
Task 6—Managing IP Addresses by Using DNS
- About Managing IP Addresses
- How to Create a Reverse DNS Zone
Task 7—Using HP OpenView to Create the SNMP Framework
Task 8—Using CiscoWorks 2000 Resource Manager Essentials
- About CiscoWorks 2000 RME

Task 5Setting Up a Web Portal for the Dial NMS

About HTTP Access to the CLI

&'

Basic Dial NMS Implementation Guide

Figure 22 Cisco IOS CLI Commander

For the source code that created the Cisco IOS CLI Commander in Figure 22, go to

http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/dialnms/httpcli.txt